1 · Upload paste layer

↑

Drop or choose your paste layer

SVG, Gerber, .gtp, .gbp and more

Start with your PCB paste layer. Processing stays in this browser.

2 · Board edge cuts

Optional

⌑

Add board outline

Gerber or SVG edge cuts

Add Edge_Cuts.gbr, .gm1 or .gko to size the stencil to your board and enable a locating lip.

Size is set by the edge cuts outline

Width

Height

Thickness

Tiny pads are included by default. Resin printers are recommended below 0.1 mm.

Click and drag in the preview to toggle pads.

Enable lip

Lip Height

Match this to your board thickness.

Wall Thickness

Fit Clearance

Tune this for your printer and material; increase it if the fit is too tight.

Columns

Rows

Solid panel fill

Outer panel padding

Adds room only around the outside of a solid panel; boards and their lips do not move.

Load a paste layer SVG or Gerber to begin

Review the model, then export a ready-to-print STL.

Awaiting paste layer

▧

Upload a paste layer to create a printable stencil in three simple steps: upload, tune, export.

Drag to rotate, scroll to zoom